CRIB LIGHTING - Y04
Installation MANUAL
WALL UNIT INSTALLATION
ULDC-Z INSTALLATION
WALL UNIT INSTALLATION
1. Safety Warnings
- The product must be installed by professional electricians.
- Turn off the main power in the electricity box and confirm the fire wire is not alive with a test pencil.
- The product should be kept away from fire and water during installation and use.
- The product can not be used in moisture circumstances such as the bathroom.
- Please note the product does not support POE power supply. Do not connect the PoE switch to this product which would cause damage to the product.
2. Installation Instructions
- Turn off the main power in the electricity box and confirm the fire wire is not alive with a test pencil.
- Remove the base of the Smart Switch and install it in the wall box (as shown in the pictures following).
- Check the wires and make sure the wires are in good contact with the terminals and no exposed copper wires.
- Fasten the base to the wall box with mounting screws and fix the Smart Switch back to the base.
- Note that the screws should not be fixed too tight during installation in case any deformation or damage to the screen and hardware.
- If the Smart Switch is not flat after installation, do not press the screen violently, please check the wallbox and the base installation at first.
3. Wire Connection
- Make the connection as shown.
![](https://www.criblighting.com/wp-content/uploads/2024/05/Installer-Manual-05-min-1024x975.png)
4. Chassis Mount
- Place it in the correct direction
![](https://www.criblighting.com/wp-content/uploads/2024/05/Installer-Manual-06-min-962x1024.png)
2. Mount it with a screwdriver.
![](https://www.criblighting.com/wp-content/uploads/2024/05/Installer-Manual-07-min-1024x894.png)
ULDC-Z INSTALLATION
1. Safety Warnings
- The product must be installed by professional electricians.
- Turn off the main power in the electricity box and confirm the fire wire is not alive with a test pencil.
- The product should be kept away from fire and water during installation and use.
- The product can not be used in moisture circumstances such as the bathroom.
- Please note the product does not support POE power supply. Do not connect the PoE switch to this product which would cause damage to the product.
2. Installation Instructions
- Turn off the main power in the electricity box and confirm the fire wire is not alive with a test pencil.
- Remove the base of the Smart Switch and install it in the wall box (as shown in the pictures following).
- Check the wires and make sure the wires are in good contact with the terminals and no exposed copper wires.
- Fasten the base to the wall box with mounting screws and fix the Smart Switch back to the base.
- Note that the screws should not be fixed too tight during installation in case any deformation or damage to the screen and hardware.
- If the Smart Switch is not flat after installation, do not press the screen violently, please check the wallbox and the base installation at first.
3. Wire Connection
![](https://www.criblighting.com/wp-content/uploads/2024/05/Screenshot-2024-05-01-at-20.51.32.png)
frequently asked questions
How can I complete setup?
You can review our setup manual in criblighting.com
How can I complete setup?
You can review our setup manual in criblighting.com
How can I complete setup?
You can review our setup manual in criblighting.com