1. Safety Precautions
IMPORTANT SAFETY INSTRUCTIONS
- Installation should be performed by qualified personnel
- Follow local building and electrical codes
- Ensure proper battery installation
- Protect device from extreme temperatures and moisture
- Keep device away from strong electromagnetic sources
- Do not modify or disassemble the device
2. Package Contents
- UWS-M1 Sensor Unit
- Mounting Bracket
- 2x AA Batteries
- Mounting Hardware Kit
- Quick Start Guide
- Mounting Template
3. Pre-Installation Planning
3.1 Location Selection
- Choose an indoor location
- Mount 2.1m to 2.4m above floor level
- Avoid direct sunlight
- Keep away from heat sources
- Avoid moving objects in detection zone
- Consider traffic patterns
- Maintain clear line of sight to monitored area
3.2 Coverage Planning
- Consider detection range (up to 10m)
- Plan for 90° detection angle
- Account for potential blind spots
- Consider overlapping coverage for critical areas
- Plan gateway placement if applicable
- Consider potential interference sources
4. Installation Procedure
4.1 Physical Installation
- Wall Mounting:
- Use provided template to mark holes
- Drill appropriate holes for surface type
- Install wall anchors if needed
- Attach mounting bracket
- Secure sensor to bracket
- Adjust angle as needed
- Ceiling Mounting:
- Follow same procedure as wall mounting
- Consider detection cone orientation
- Adjust sensor angle for optimal coverage
- Verify stable mounting
4.2 Battery Installation
- Open battery compartment:
- Locate battery door on rear of unit
- Press tab to release
- Remove cover carefully
- Install batteries:
- Insert 2x AA batteries
- Observe correct polarity
- Use only new batteries
- Do not mix battery types
- Close battery compartment:
- Replace cover
- Ensure proper seal
- Verify latch engagement
5. Device Configuration
5.1 Initial Setup
- Download mobile app:
- Available for iOS and Android
- Follow app store instructions
- Create account if required
- Enable Bluetooth®:
- Activate on mobile device
- Stay within range of sensor
- Verify Bluetooth® version compatibility
- Pair device:
- Open mobile app
- Follow pairing instructions
- Confirm successful connection
- Note device ID or name
5.2 Basic Configuration
- Motion Detection Settings:
- Set sensitivity level
- Configure detection period
- Adjust alarm duration
- Set hold time
- Environmental Monitoring:
- Configure temperature alerts
- Set humidity thresholds
- Enable/disable sensors as needed
- Set sampling intervals
- Communication Settings:
- Configure transmission interval
- Set advertising power
- Enable/disable protocols
- Configure gateway connection (if applicable)
6. Testing and Verification
6.1 Coverage Testing
- Perform walk test:
- Verify detection zones
- Check blind spots
- Confirm range limits
- Test different approach angles
- Verify Settings:
- Confirm sensitivity
- Test hold time
- Check alarm function
- Verify data transmission
6.2 System Integration
- Gateway Connection (if applicable):
- Verify communication
- Check signal strength
- Test data flow
- Confirm alerts
- Mobile App Verification:
- Check real-time updates
- Verify alert reception
- Test configuration changes
- Confirm data logging
7. Troubleshooting
7.1 Common Issues
- No Detection:
- Check battery installation
- Verify mounting height
- Clear obstacles
- Check sensitivity settings
- Communication Problems:
- Verify Bluetooth® enabled
- Check range to gateway/mobile
- Confirm proper pairing
- Check device settings
- False Alarms:
- Adjust sensitivity
- Remove interference sources
- Check mounting stability
- Verify environmental conditions
8. Maintenance
- Replace batteries when indicated
- Clean sensor lens periodically
- Check mounting security
- Update firmware when available
- Document configuration changes
- Perform periodic testing
Need Help?
For technical support:
- Email: support@criblighting.com
