1.Installation Instructions
1.1 Safety Precautions
- Installation must be performed by qualified personnel
- Turn off power supply before installation
- Follow local electrical codes and regulations
- Ensure proper grounding
- Keep device away from water and high humidity
- Do not install near heat sources
1.2 Mounting Requirements
- Standard 86mm wall box compatibility
- Minimum 50mm mounting depth
- Dry, indoor location required
- Operating temperature: 0°C to 40°C
- Humidity range: 5-90% non-condensing
1.3 Installation Steps
1.Power Preparation
- Disconnect main power
- Verify power is off using appropriate tools
- Identify correct wiring connections
2.Wall Box Installation
- Mount wall box with minimum 50mm depth
- Ensure box is level and properly secured
- Route all necessary cables into box
3.Panel Mounting
- Connect power and network cables
- Attach mounting bracket to wall box
- Secure panel to mounting bracket
- Verify panel is level and properly seated
4.Network Connection
- Configure Wi-Fi or connect Ethernet cable
- Verify network connectivity
- Test communication with ULDC system
2. Interface Configuration
2.1 Initial Setup
- Power on the device
- Select language and time zone
- Configure network settings
- Connect to ULDC system
- Verify system communication
2.2 ULDC Integration
- Network Configuration
- Configure device credentials
- Test connection status
- Device Discovery
- Scan for available ULDCs
- Add devices to interface
- Verify device communication
- Scene Configuration
- Create lighting scenes
- Set up schedules
- Configure automation rules
3. Operation Guideline
Complete the installation by following the Setup Manual steps.
4. Troubleshooting Guide
4.1 Common Issues
- Display Issues
- Screen not turning on
- Check power connection
- Verify input voltage
- Check for physical damage
- Touch not responding
- Clean screen surface
- Restart device
- Check for software updates
- Screen not turning on
- Network Connection Problems
- Wi-Fi Connection
- Verify network credentials
- Check signal strength
- Reset network settings
- Ethernet Issues
- Check cable connection
- Verify network settings
- Test network connectivity
- Wi-Fi Connection
- ULDC Communication
- Device Not Found
- Check network connectivity
- Confirm device ID
- Control Not Working
- Verify device status
- Test connection stability
- Device Not Found
5. Maintenance
- Regular Maintenance
- Clean screen with soft cloth
- Check connections periodically
- Update firmware when available
- Backup configuration data
- Preventive Measures
- Keep ventilation clear
- Avoid direct sunlight
- Protect from moisture
- Monitor system logs
